Viewing 15 posts - 1 through 15 (of 21 total)
    • Author
      Posts
    • #10301
      MyPrevost
      Keymaster

      All the CC/front shield guy, I have a question.

      I opened the bay to the generator, a PTS 17.5, and the whole area was covered with sand and fine dust. I’m not sure how this area should look after 3000 or so miles and 30 hours of gen. useage. I cleaned the filter to the compartment and checked the air filter to the gen. it’s self. The cover to the air filter has the rubber insert to remove and dump out dirt—I did and a fair amount of ‘talc’ looking dust came out.

      The gen. was serviced prior to delivery, all filters and fluids, and was spotless. I ran on paved roads only. I did park on mostly gravel sites while in the AZ. area.

      Am I concerned about nothing or do I need to seal up the compartment with better filter material?

      Thanks for the input.

      #10303
      MyPrevost
      Keymaster

      30 hrs of gen time is relatively nothing. If things went from clean to dirty in that amount of time you would of had to be in some pretty terrible conditions. We have no filter on the compartment itself. We have a a opening covered with a stiff mesh. I can run it for months and the gen bay requires a quick spritz with 4-09 or Fantastic.

      #10304
      MyPrevost
      Keymaster

      30 hrs of gen time is relatively nothing. If things went from clean to dirty in that amount of time you would of had to be in some pretty terrible conditions. We have no filter on the compartment itself. We have a a opening covered with a stiff mesh. I can run it for months and the gen bay requires a quick spritz with 4-09 or Fantastic.

      #10305
      MyPrevost
      Keymaster

      Larry, my generator compartment does the same thing. Gets dirty real fast with the same kind of grit/sand you describe. I just hose it clean before I wash the coach. The air filter is never real bad but I blow it out every time I change the generator oil. I don’t think you have a problem.

      #10306
      MyPrevost
      Keymaster

      Ted & Jan, where do you think the sand is getting in? The compartment filter wasn’t that dirty and it should have been for the amount of sand. The bay door seal seems good and tight as well. Is there another hole somewhere I haven’t found? Do you run your gen alot enroute?

      Joe, so how does your compartment stay so clean?

      Is the sand coming in as a result of running or as a result of going down the road.

      #10307
      MyPrevost
      Keymaster

      Where is the radiator located, and does it have a fan? You may be pulling in fresh air.

      #10308
      MyPrevost
      Keymaster

      Where is the radiator located, and does it have a fan? You may be pulling in fresh air.

      #10309
      MyPrevost
      Keymaster

      Where is the radiator located, and does it have a fan? You may be pulling in fresh air.

      #10310
      MyPrevost
      Keymaster

      Like Gary says, the radiator fan is the likely culprit here. I will take a close look tomorrow and see exactly how my compartment is set up and where the opening that is letting the grit in is located. I run the generator most of the time while driving.

      #10311
      MyPrevost
      Keymaster

      Like Gary says, the radiator fan is the likely culprit here. I will take a close look tomorrow and see exactly how my compartment is set up and where the opening that is letting the grit in is located. I run the generator most of the time while driving.

      #10312
      MyPrevost
      Keymaster

      Larry,

      There is a hole under the generator, probably 18″ square with a screen and a foam filter pad that draws in cooling/combustion air. Mine requires the services of a double jointed midget to attack, in the 40 there is an access port in bay 1L, don’t know about a 45. Should you not have that foam pad, spect that your unit has been vacuming the ground under the coach..my guess!

      Also Arizona is full of sugar sand…by that I mean that stuff that looks like talc and if you had the generator running and it was sucking in that stuff…nuff said.

      John

      #10313
      MyPrevost
      Keymaster

      John, I DO have the fibermat{?} in the hole. Not sure about the fan location as Gary and Ted spoke of.

      Ted, keep me posted if you find the fan air source.

      #10314
      MyPrevost
      Keymaster

      Larry,

      Mine is mounted fore/aft in bay 2L. Hole is between bays 1L and 2 L. Fan/fan belt all that stuff mounted on the engine between radiator and the block, facing aft.

      I do not get any dirt to speak of, the air filter on the engine (identical to yours) remains clean. Btw, in this access compartment is also the battery for generator start/stop….PITA to check/change…not charged by anything but the generator.

      John

      #10315
      MyPrevost
      Keymaster

      John, mine is configured a bit differently but I will dig a little deeper in the AM.

      Thanks

      #10316
      MyPrevost
      Keymaster

      John, mine is configured a bit differently but I will dig a little deeper in the AM.

      Thanks

    Viewing 15 posts - 1 through 15 (of 21 total)
    • You must be logged in to reply to this topic.
    Top